Specification
|
product: |
silver paste |
|
Part number: |
01L-3608B |
※ Heat-cure the silver paste at a temperature range of 150 to 200 degrees Celsius.
※ Maximum operating temperature: 300℃. Within a short period of time (2 hours), it can reach 350℃.
※80 to 200 is used for bonding chips, ceramics, glass, metals, etc.
※ Soldering and printing are both possible.
Application:
Single component conductor paste series, the paste is suitable for pasting various chips into the circuit board, glass, ceramic and other substrates, matching with the substrate is good.
|
Substrate |
Thick film circuit, glass, ceramic, metal.，Pc etc |
|
|
Method of use |
Dispensing ( by needle cylinder, etc.)，Printing |
|
|
Leveling |
3-5min minutes at room temperature |
|
|
Curing conditions |
In a constant-temperature oven, or with continuous hot air (either of these conditions is sufficient) | |
|
150℃ |
60分钟/mins |
|
|
180℃ |
30分钟/mins |
|
|
200℃ |
30分钟/mins |
|
|
250℃ |
20分钟/mins |
|
|
Resistivity |
≤20mΩ/□ | 100mm*1mm Cured film thickness 10-25μm, test pattern 100mm * 1mm |
|
≤10mΩ/□ |
Four-needle probe 25.4u |
|
|
Viscosity |
120-220Pa.s |
Brookfield HBT utility cup and spindle (SC4-14/6R), 10rpm, 25±1℃， |
|
content |
65-80% |
银 Silver，Glue |
|
Adhesion |
Not fall off |
3M 600#Tape 90°Pull |
|
Differences |
01L-2608B | Adhesive type, with balanced conductivity, suitable for most products |
| 01L-2609S | Greater adhesion, but slightly larger than that of 01L-2608B resistor. | |
operating conditions
|
Substrate |
Thick film circuit, glass, ceramic, metal. |
|
|
Method of use |
Dispensing ( by needle cylinder, etc.)，Printing |
|
|
Leveling |
5-10min minutes at room temperature
|
|
|
Curing conditions |
||
|
150-200℃, 30 min ( It could be cured at a temperature between 130 ~ 180°C, but it depends of the thickness and the substrate.) |
||
|
Thinner |
ST-1001 | |
Characteristics：
|
Characteristic |
Standard |
Test method and conditions |
|
|
1 |
Fineness |
≤15μm |
FOG test |
|
2 |
Viscosity |
80-280Pa.s |
Brookfield HBT utility cup and spindle (SC4-14/6R), 10rpm, 25±1℃，
|
|
3 |
Solid content |
70 |
Silver |
Characteristics after firing：
Check fired film produced under the conditions specified in 1）,
|
Characteristics |
Standard |
Test method and conditions |
|
|
4 |
Resistivity |
≤30mΩ/□ |
|
|
5 |
Hardness |
4H
|
Pencil hardness |
|
Shear strength |
12Mpa | ||
Storage condition and Term of validity
The product shall be guaranteed for 6 months after shipping date, keep tightly under at 5-15℃
Packaging method：
Standard package 1000g/can，if you need sample to test, available 200g with small package
